Home Page

 

 

 

 

IMPORTANT NOTICE:

Carbide chain is not indestructible!

Make sure you have the chain designed for your application.

Chain designed for wood cutting will be damaged by impacting with
rock, stone, concrete, or hardened metals.

Our tough carbide can withstand more impact but can still be damaged
by impact with metals, or other hard objects.

 

When breaking in a new chain, run it at a low speed for two minutes, pumping extra oil on the chain. Stop motor and check tension again. If it has loosened, tighten it to the correct tension. Check again after a few easy cuts and readjust if necessary. Keeping your chain properly tensioned, will extend its life and enhance its cutting performance.

RAPCO™ chain is fully guaranteed against defects in workmanship on the silver solder for thirty days. In as much as RAPCO™ carbide chain was designed for cutting wood in abrasive conditions, it will not cut through rocks, steel, or other hard objects without sustaining damage to the carbide. Because of the normal abuse expected, fire department chain is not warranted. All request for warranty must be approved by the factory

Available In:

 

3/8” x .050

3/8” x .058

 

.325” x .050

.325” x .058

 

Available In:

 

 3/8” x .063

.404 x .063

 

Rapco Carbide Chain

4450 Park Street  Moline MI  49335

Ph: 616-877-4711  Fax: 616-877-4070